Step 1: Add HTTP license sent from NETMc to the DVR
Click on "SETUP" button on NetMC window
2. Click on the “LICENSING” button
3. Click on “LOAD FROM FILE” button and add the HTTP
4. Ensure HTTP has been added to Downloads
Step 2: Setup Serial Port Configuration for Overlay
Please Note - Make sure its connected to the correct serial port (one is survey data, one is Enaimco)
Click on "OVERLAY" button
Click on "SETUP" button
Click on “IN #” in “SERIAL PARSER” that matches the COM port the Serial cable is connected over.
When this page initially opens, all the containers are closed. Click Input Type + icon, select raw data stream, select block end.
Make the configuration the same as the image below. Make sure to click “APPLY” button after the configuration as been added.
After clicking on the inspection, activity and focusing on a component, connect to the DVR from the inspection page, using the steps provided in this guide.
Click on "LIVE SOURCE" to see the inspection data coming from the Enaimco app.
The application needs to be configured as well in order to click asset and focus component.
Click on “OUT#1” in the “SERIAL PARSER” to connect the “FriendlyName” in “IN #” to the “OUT #1”. Make sure to click “APPLY” button after the configuration as been added.
Step 3: Configure file paths for recording, clipping, and still images
Click on "SETUP"
2. Set “RECORD PATH” to \{Campaign Name}\Recordings\
3. Set “RECFILE PREFIX” to “record-”
4. Set “CLIP PATH” to \{Campaign Name}\Clips\
5. Set “CLIPFILE PREFIX” to “clip-”
6. Set “STILL PATH” to “\{Campaign Name\Stills\
7. Set “STILLFILE PREFIX” to “still-”
8. Click on the “APPLY” button after configuring the paths